I have a year old worchester / bosch boiler and the pressure has gone below 1. How do i re fill it ? - bosch boilers
There must be a cycle of filling with a short tube. Connect the hose, the valve slowly to open and closed, then close the valve when the correct pressure.
Wednesday, January 13, 2010
Bosch Boilers I Have A Year Old Worchester / Bosch Boiler And The Pressure Has Gone Below 1. How Do I Re Fill It ?
7 comments:
There should be a brass tap on a pipe coming from the boiler, turn and heard a noise and ground, the pressure increases.
There should be a brass tap on a pipe coming from the boiler, turn and heard a noise and ground, the pressure increases.
Mine has a high water-line tap, open it and see the display, turn it off when the correct pressure
Shoudln't Nimbus system.tut.tut has a faucet
There must be a connection between the Swiss system and the provision of cold. There is often a linkage between 2 and service valves can not be a permanent connection (the water to prevent CH finally) back to the cold water. The normally near the boiler. Log in and cancel the service valves, will increase the pressure. Once done close to the Walvis and disconnect the hose.
There must be a loop of the filling on each system .... try in the plant or in the sink or other place in the neighborhood, where water supply.
outside the boiler, which had to get a key, if the IDC is an area
Most of the new Worcester boiler filling loop integral
Key to the key and the squirrel, until the correct pressure
Worcester Technical or ring 08705 266241
outside the boiler, which had to get a key, if the IDC is an area
Most of the new Worcester boiler filling loop integral
Key to the key and the squirrel, until the correct pressure
Worcester Technical or ring 08705 266241
Post a Comment